1. After the mixer is in place, it must be placed smoothly and fixed with foundation screws.
2. Before debugging, clean the inner chamber of the mixer and lock the front cover with a star shaped handle.
3. After turning on the power, pay attention to its phase sequence and rotate the spindle in the direction shown.
4. During debugging, pay attention to any abnormal noise inside the mixer for timely inspection.
5. Install the storage bag in the discharge hopper.
Mixer maintenance knowledge
1. The lubrication finger on the bearing seat of the mixer should be replaced regularly.
2. The temperature rise of the mixer bearing seat shall not exceed 35 ℃.
3. Do not arbitrarily remove the electrical appliances and belt protective covers of the mixer.
Introduction to Installation and Maintenance of Granulator
1. Maintenance of the granulator:
1. The bearing bears all the load of the granulator, and good lubrication is closely related to the service life of the bearing. It directly affects the service life and operating rate of the granulator. Therefore, it is required that the injected lubricating oil be clean and well sealed. The main oil injection positions of the granulator (1) rotating bearings (2) roller bearings (3) all gears (4) movable bearings and sliding surfaces
2. Newly installed tires are prone to loosening and must be checked regularly
3. Pay attention to whether all parts of the granulator are working properly
4. Pay attention to checking the wear level of vulnerable parts and replace them at any time